rockytopper

I purchased a stand alone wiring fuse and relay junction box. Refer to page 3of this link.
http://www.goindesign.com/ebay/SA1000.pdf

It has only 2 fan relays in the circuit. The stock set up uses 3 relays. Will this do te trick for me as it is with 2 relays only? please advise.

LS1MCSS

iTrader: (18)

I would use three relays and the schematic in the sticky. It's proven to work.

https://ls1tech.com/forums/showthrea...wiring+correct

rockytopper

I would do that but I already got money tied up in this. Now with that said this unit has additional relays that are used for other functions that I'm not going to use. But I would perfer not to have to gut this plug and play unit and try to rewire it to use the third relay. I don't really care if I have all the functions of the fans like one slow, or 2 slow or both fast. I simply want them to kick on when they reach temp. Noise is not an issue with me. I have to pusher fans in this car that simply turn on full blast when I turn the ignition on. But I would perfer that they not come on until needed. But again I don't need the full functions of the 3 relay set up unless this setup as wired want work period.

blackrose90

I have mine wired with 2 relays just like shown in the diagram. They come on at 200 degrees and go off at 190. Have had no problems.
Jeff

rockytopper

Thanks Jeff, nice ride by the way, dig the color selection!