ABS Brake Module Needs VSS Input-Where From?
#1
ABS Brake Module Needs VSS Input-Where From?
Have Wait4Me Computer & Harness as a stand-alone LS1/4l60E installation. Only wire(white) not connected to my ABS Module, and that is required to function, is a VSS input. There is no provision for this on my harness, other than a VSS output for the speedometer function. Any idea where I could pull another VSS output from? Many thanks...
#4
TECH Veteran
iTrader: (37)
You need to find a pin out for a ls equipped fullsize truck. I am not at work today but can get you a diagram tomorrow. The abs uses what is called a high resolution speed signal input from the pcm. That is the pin you need I am just not sure what connector or location off the top of my head. It is a yellow with black tracer out of the pcm.
#5
VSS Signal Wire For ABS Module
You need to find a pin out for a ls equipped fullsize truck. I am not at work today but can get you a diagram tomorrow. The abs uses what is called a high resolution speed signal input from the pcm. That is the pin you need I am just not sure what connector or location off the top of my head. It is a yellow with black tracer out of the pcm.
Trending Topics
#10
TECH Resident
iTrader: (148)
Join Date: Dec 2006
Location: Crete, NE & Berthoud, CO
Posts: 848
Likes: 0
Received 0 Likes
on
0 Posts
HA sweet. Thats good to know. ever since i swaped in my ls1 into my s10 my abs an brake light are on and i coulfn't figure out why....now i know why!
Thanks 01WS6/tamu....now i can get a few dash lights shut off!!
Thanks 01WS6/tamu....now i can get a few dash lights shut off!!
#11
TECH Resident
iTrader: (148)
Join Date: Dec 2006
Location: Crete, NE & Berthoud, CO
Posts: 848
Likes: 0
Received 0 Likes
on
0 Posts
I just checked my truck out. I have the yellow and black wire that goes to the ABS module. Pin 49 is not used on my 2002 LS1 ECM. If i put my own pin in the spot it should work, correct?