NoClassic

iTrader: (42)

The transmission portion of the harness has been cut just as it branches from the main loom. I know that the solenoid control plug, VSS, and two other trans plugs are missing. After reading some more and speaking with someone with more harness experience than I, it seems there is a possibility that I may need more plugs than previously mentioned.

What am I going to need to make this thing right.

busta9876

iTrader: (3)

what kind of harness are we looking at here??? I've got a few 4L60E trans connectors kicking around with about 4-5 feet of wire on them, also o2 connectors, vss, etc...mostly from truck harnesses. If f-body i think the o2's are flat 4 pin..most trucks were square 4 pin.

good luck.

NoClassic

iTrader: (42)

Its supposed to be from a 99 fbody.

I would be very interested in the trans harness section if you would be willing to let one go. I basically need everything in that leg of the harness if you happen to have it.

Frost

iTrader: (45)

Fbody o2 connectors are square, 4 terminals, and the connector is gray.

I'll email you tomorrow Ryan, I'm on my phone right now.

busta9876

iTrader: (3)

humm..not sure what all is on that bundle of wires for auto trans harness...

Looking at this M6 harness, the fron't o2's come out of harness near starter, and at front of drivers side head...i'm guessing the rear o2's run down the part going to the trans..not sure...

Eddie 70

iTrader: (3)

Here is an 02 automatic harness. There is a post somewhere on here that has each connector labeled. Let me see if I can find it again.

Eddie 70

iTrader: (3)

Here is the post I was thinking about with a picture that has the connectors labeled. But, it is for a manual car.

NoClassic

iTrader: (42)

Great info Eddie. I think I pretty much figured out what I need.

4l60e main plug
Smaller trans plug(unsure of function just yet)
VSS
Drivers rear O2