LS Computer Help!!!
#1
LS Computer Help!!!
I have an ls6 with a cable throttle body... I am putting this in a 69 chevelle... i am using a 5.3 vortec computer but had it flashed to ws6 specs with maf sensor , front 02 sensor, etc... when i crank up the motor, it will start and rev up for 2 sec then die... the computer guy says the program is not sticking... any ideas why it wont run... i have 60psi to the fuel rail, all injectors are working properly... all sensors are new... Why wont it stay running??? ANY HELP GUYS??
Do i need a new ecu??
Do i need a new ecu??
#6
TECH Enthusiast
iTrader: (13)
Join Date: Sep 2007
Location: SC
Posts: 666
Likes: 0
Received 0 Likes
on
0 Posts
Any DTCs? That sounds exactly like what I had when I didn't have VATS turned off.
Yes, computers can go bad. Usually all it takes is a good shock, or exposure (read: submersion) to alot of water. Sometimes they just crap out.
What does your tuner mean by "not sticking"? I'm sure if the tune wasn't saving, the software would let him know that it couldn't be flashed.
Yes, computers can go bad. Usually all it takes is a good shock, or exposure (read: submersion) to alot of water. Sometimes they just crap out.
What does your tuner mean by "not sticking"? I'm sure if the tune wasn't saving, the software would let him know that it couldn't be flashed.
#7
TECH Resident
Join Date: Dec 2001
Location: Lexington Park, MD
Posts: 922
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#8
TECH Enthusiast
iTrader: (13)
Join Date: Sep 2007
Location: SC
Posts: 666
Likes: 0
Received 0 Likes
on
0 Posts
Yea. I think it's time he went hunting for a new tuner. If VATS was in fact deleted, then it should run. I had VATS deleted off of mine, and it ran fine(except for the damn high idle I'm troubleshooting). If in fact his software isn't "sticking" then he wouldn't have VATS deleted, correct?