Trying to install these manual brakes! Help
08-11-2013, 12:31 PM
#1
TECH Apprentice
Thread Starter
iTrader: (17)
Join Date: Dec 2010
Location: Virginia Beach
Posts: 398
Likes: 0
Received 0 Likes
on
0 Posts
Trying to install these manual brakes! Help Ok I got strange front drag brakes and I'm trying to install this manual master cylinder. I did the one inch hole on the pedal and bled the hell out of it. The pedal is hard as hell the wheel feels like it does not want to spin freely and when I press the brake pedal down it does not want to come back up it stays down
Any help
Any help
Trending Topics
08-11-2013, 05:02 PM
#9
TECH Apprentice
Thread Starter
iTrader: (17)
Join Date: Dec 2010
Location: Virginia Beach
Posts: 398
Likes: 0
Received 0 Likes
on
0 Posts
i did the same thing, did you have a abs delete? if you did which lines went where?
i have a line lock and a proportioning valve? i want to make sure i dont have the lines on the master backwards
i have a line lock and a proportioning valve? i want to make sure i dont have the lines on the master backwards
08-11-2013, 05:15 PM
#11
9 Second Club
iTrader: (46)
Join Date: May 2006
Location: Fredericksburg, VA
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
You have to have that washer in there. From looking at the pic its not in there. It will cause the brake to hang up and the pedal wont return all the way.
08-11-2013, 06:31 PM
#14
9 Second Club
iTrader: (46)
Join Date: May 2006
Location: Fredericksburg, VA
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
my car is at a chassis shop right now so I cant get you a pic. im pretty sure mine was just a 3/8" bolt though. so just stick a fender washer on it. where did you get the master from?
