1000+ street/strip 98 ss project car
#21
TECH Fanatic
Thread Starter
I am going to see how far these 2 pumps will take me. A lot of speculation and a lot of potential for the price. If they fall short Ill buy one more.
#22
TECH Fanatic
Thread Starter
I am going to try out this PATC converter. My friend has a low 10 second turbo silverado and loves his converter. Made me give them a shot. I have only seen and used one patc before in a cam only setup. Seemed nice. I hope it works great for me!
#24
TECH Fanatic
Thread Starter
Fuel Injector Development 160 lbers. I have used and sold quite a few of these injectors. I really like them. If anyone is ever in the market let me know. I get these for a great price.
#25
TECH Fanatic
Thread Starter
Made a little sunday progress. Installed the TRZ anti roll/panhard setup. Took a lot longer then I expected but I got the front end all mounted. It is not finalized obviously but looks good. Only 7lbs of cromoly! I am stoked.
#26
TECH Fanatic
Thread Starter
My buddy finished the transmission last night. Pretty stoked! Just waiting on getting the block back from the damn machine shop so I can slam the motor together and get it in the car for mock up.
#27
TECH Fanatic
Thread Starter
Ended up ordering the Pro Flo fuel rails even though they are 3/8". I was going to try and make the 1/2" holley rails fit but I didnt want to end up having a fuel leak and run the rails drilling holes into them.
Tires came today. Shiiit, Im getting pretty close to slamming this thing together.
Currie enterprises 9" tq arm adapter. I should have just built one of these. For whatever reason this thing didnt fit very good and I had to trim it with a plasma cutter. It is definitely heavy duty though.
Tires came today. Shiiit, Im getting pretty close to slamming this thing together.
Currie enterprises 9" tq arm adapter. I should have just built one of these. For whatever reason this thing didnt fit very good and I had to trim it with a plasma cutter. It is definitely heavy duty though.
#31
TECH Fanatic
Thread Starter
But yea I was pretty pissed about the Currie bracket actually. I was going to make one for as cheasy as the design is. But I wanted to focus the time spent on something more worth while. I had to cut and shave the center section to get it to fit. I have several hours into it. I wish I would have just built my own and saved 165 dollars.
#34
TECH Fanatic
Thread Starter
Well I got the block back from the machine shop today. Bored to accommodate the 3.80 bore pistons and new cam bearings installed. after a long day at work and running around after, I did all of the ring end gaps and stuff. I will have the motor completely assembled tomorrow.
#37
TECH Fanatic
Thread Starter
Got quite a bit done this weekend. Already racked up a lot of time into this car. Not nearly as far as I had hoped. Few little things I have made so far. The trans bracket came out pretty nice. My welds are getting better.Still working on my hand steadiness and starting and stopping.