cwaldt

iTrader: (4)

Got my 325's on this weekend. It wasn't that hard to get them to fit. The rear wheels are 15x10 w/ 4.5 backspacing. I had my Moser 9" narrowed 3" per side. The fronts are 15x4 w/ 1.75 backspacing. These are the Jegs wheels not the Welds.













I have some more pic's of what I had to do to get them to fit. As stated the rear was narrowed 3" per side. Also had to have the adj. LCA's and panhard bar, adj. torque arm as well.

gator's 99TA

iTrader: (2)

how much cutting of the inner fender did you have to do? do the rear wheels stick out at all? hard to tell.

cwaldt

iTrader: (4)

Had to do a good bit of cutting and hammering. The wheels are even with the fender. I didn't have to roll the fenders either.

cwaldt

iTrader: (4)

Heres a pic to see how it lines up with the fender.



What do you guys think about lowering the car about an inch in the back or should I leave it where it is.

1998TA__1991RS

iTrader: (23)

nice, but the tires are on backwards

cwaldt

iTrader: (4)

Yep, you got me. I checked to make sure they were mounted on the wheels right and then just stuck them on the car. I'll change them when I put my center section in this weekend.

HAMRHEAD

iTrader: (8)

Looks nice!

tektrans

iTrader: (23)

Looks good.

Beaflag VonRathburg

iTrader: (176)

Lower it. It will look better and help preload the suspension.