brandonppr

iTrader: (9)

I want to use a torque arm that mounts to the tunnel brace but it want work with my xpipe and the xpipe hits things and drags.
I always heard that xpipe was better than going with td with no x or h pipe but here lately I have heard of a lot of people runnig strait off the headers with out a xpipe. I had it like that before untill I got new mufflers and got an xpipe. I don't know if I got any gains from it but I don't think I did. I had fixed another problem at the same time so I don't know.

pontiac

iTrader: (4)

thoguht about doing this as well, want better tq arm, but do not want to do another exhuast, just like a test pipe with a bullet and dumps out to the side.

bad2000z

iTrader: (4)

I wanna know too. Also what muffler to use so it's not retardedly loud inside the car?

pontiac

iTrader: (4)

if i do it i am using the dynomax bullets

SLPSS99

iTrader: (7)

I am doing a set off the headers also ether the spiral flows of if I can find a way to get 1 chambers to fit I am going to do those.

Dan

brandonppr

iTrader: (9)

thats what I have now. I bought a ta and am going to move the spiral flows to the front behind the headers with about a foot extension. plus this will save weight.