What are the rules for safety equipment in 1/4?
#1
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Aug 2006
Location: DE La Ware
Posts: 1,094
Likes: 0
Received 0 Likes
on
0 Posts
What are the rules for safety equipment in 1/4?
Kinda vague title but I know sometimes at the track if you run to fast they dont let you run anymore. Whats the deal with that on just like a grudge night or test and tune?
#2
10 Second Club
iTrader: (10)
Join Date: Jun 2005
Location: cape cod mass
Posts: 570
Likes: 0
Received 0 Likes
on
0 Posts
look up the tracks in ur area either IHRA or NHRA. the track u run the first thing u need is a roll bar and screw in valve stems and drive shaft loop. 11.49 and faster. a 6 pnt. is good for 11.01 then a bunch more **** is needed, it cost a lot to go fast and some more to race fast
#3
9 Second Club
iTrader: (21)
look up the tracks in ur area either IHRA or NHRA. the track u run the first thing u need is a roll bar and screw in valve stems and drive shaft loop. 11.49 and faster. a 6 pnt. is good for 11.01 then a bunch more **** is needed, it cost a lot to go fast and some more to race fast
At NHRA tracks there is things you need based on the time you run..
anything faster than 14.00 you need a helment that is SNELL approved
11.49 and faster is when it gets bad
6 point rollbar is needed
5 point harness is needed
single layer SFI approved jacket is needed
Drive saftey loop anytime your running slicks or under 11.49
uhhhh... i know there is more but those are the main things
and there are a lot more for 9.99 or faster