Setting up Hal's
#1
Teching In
Thread Starter
iTrader: (4)
Join Date: Dec 2002
Location: Lancaster, PA
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Setting up Hal's
I just installed my front and rear Hal shocks and am using the Hal springs up front. My question is, where do I set the springs at. I have a spring compressor so it shouldn't be hard, I just don't know where to set them. Any info would be appreciated. Thanks
#2
11 Second Club
Join Date: May 2003
Location: USA-WEST MONROE, LOUISIANA
Posts: 631
Likes: 0
Received 0 Likes
on
0 Posts
Re: Setting up Hal's
I would set the springs to achieve the same height as it was from factory. I measure the lenght in inches from base of tire to fender well on both sides of car and set the springs accordingly. I like the factory height because the car is already low as it is. But you can have the car lowered if you want. Just my thoughts.