Initial Dyno Run
#1
Teching In
Thread Starter
Join Date: Oct 2004
Location: Houston, Texas
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Initial Dyno Run
Well, Got the (pre-tune) DYno results on the project 5.4 DOHC stang back. It was running very rich and the cuttouts havent been installed yet. It made 510 hp and 513 lbs tq at 5500 rpm ( took it easy on the rpms). I havent tried the 100 shot on it (want the A/F ratio to be right). Im projecting 630 or so after the cutouts, the diagnostic hurdles. Close to 700hp on the juice.
#5
Teching In
Thread Starter
Join Date: Oct 2004
Location: Houston, Texas
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Correctumundo! Its a 5.4 DOHC with aftermarket cams, rods, dished Pistons, Revolutions Chip, 42lb injectors, VortechV2-SQ supercharger, Anderson Power Pipe, UPR adaptors to fit the 01 cobra intake, Innovations West Harmonic Balancer, Bassani Shortie Headers, Bassani X-pipe, Electronic Cutouts (soon), Spintech 2 1/2 inch side exhaust, Ford Racing ALuminum Drive shaft, T-56 tranny, Steeda Tri-axe shifter, 3:73 gears, Mosser 31 spline axle, 100 shot NOS. And thats all I have to say about that.
Trending Topics
#12
Teching In
Thread Starter
Join Date: Oct 2004
Location: Houston, Texas
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Well, today we decided that we needed to put 60 lb injectors on it. Right now it is either running really rich or really lean when trying to tune. Hopefully this isnt gonna take to much longer to get finished.