kyles2000z

iTrader: (8)

04 cobra....

2.93 upper, 6 lb lower pulleys
bbk intake, catback exhaust
tune

what should this put down at the wheels?

'Trust'

iTrader: (24)

I'm sure UNIT would know and a ton of others on the board, but if you don't get your answer you could check svtperformance.com

kyles2000z

iTrader: (8)

i would but i dont feel like joining another forum and searching and all that ****. the depth of knowledge on this site about 03/04 cobras is prob just as good as over there too lol.

davered00ss

iTrader: (4)

CAI & Catback puts them right around 410-415rwhp. Smaller pully depends on the size. My best friend has a 2.8 pully, Headers back exhaust (bassani) and a Steeda CAI, FMIC, & tune. I know I'm missing some ****. And he is at 475rwhp 496rwtq. (on a friendly dyno )

xterminator

iTrader: (4)

with the 2.93 upper and the 6lb lower he is probably making 460 to 475ish hp and well over 500ft lbs

Blown2000SS

Id say 470/500

Ported blower w/ LTs he might make 510/530

2QUIK4U

iTrader: (7)

I would say around 450-460rwhp.

Tom's_03SVT

18# of boost, unported eaton on 93 octane.

Ill say....

480/525.

Tom's_03SVT

my car made that on 14# with crappy gas.

BayAreaSS

iTrader: (10)

I say 460 hp 490 tq

texasheat

440-460rwhp...headers dont seem to help out hardly at all until they have alot more boost.

ExceSSive

iTrader: (13)

Your friend has a front mount intercooler with an eaton SC?

kyles2000z

iTrader: (8)

thats what i was thinkin?

PewterScreaminMach

iTrader: (7)

475/500 give or take. Run him and find out.

Omega Doom

iTrader: (2)

the funny thing is not one of those cars will make over 500rwhp no matter what the bolt on other then nitrous! the funniest part is they drop another 3-5k on another supercharger to make more power(whipple,KB,pro charger,turbos) it is very rare but I have seen a few go a little over 510-515 but those #'s were usually onr time only #'s!

kyles2000z

iTrader: (8)

yea its very rare that i see a stock eaton car make over 500. if it does, its BARELy over 500, or the dyno numbers were too high.

BayAreaSS

iTrader: (10)

Yea i dont think a stock eaton will reach 500. My friend just dynoed on monday with his cobra. He has 2.76 pulley, cai, x pipe and catback. He put down 445hp 474tq on a dyno that is known to read about 10 hp low.

black99ls1z

my friend has an 03 cobra and on the stock sc with very similar mods (18 psi) he mad 468 hp and turned a 12.2 in the 1/4 at maple grove. he had a whipple put on and a new liquid to air intercooler and made just under 600 hp

hepcatws6

With my mods I am supposed to be putting down around 440 or so. I haven' had it on the dyno myself, though.

kyles2000z

iTrader: (8)

bunch of moeny to spend to pick up a little over 100 hp! coulda done that with some nawwwzzz! if ur gonnna spend the money for a whipple or kb, theres no reason not to go ***** to the wall and make 650+, those motors can handle it! the halfshafts wont like it much tho!