Painted my 25.5 (7.50 second ET) rollcage
#1
TECH Senior Member
Thread Starter
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
Painted my 25.5 (7.50 second ET) rollcage
Tyson at Performance Auto Fabrication did one helluva job. Only the bars above the floor are shown in this post:
Hope to get her certified in the next week or so (already talked to the NHRA inspector)...this is what it takes to go faster than 8.50 legally
Once I get my 7.50 sticker, I'll start refitting the interior panels
Also cleaned it up and got a nice picture of the back end
Hope to get her certified in the next week or so (already talked to the NHRA inspector)...this is what it takes to go faster than 8.50 legally
Once I get my 7.50 sticker, I'll start refitting the interior panels
Also cleaned it up and got a nice picture of the back end
#7
TECH Senior Member
Thread Starter
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
technically it still only intersects the frame at the same amount of points as a normal cage, but has alot more boxed structure. Its what is required by NHRA/IHRA to go faster than 8.50 anymore, even then, this cage is only built to 7.50 specifications...a 6.00 cert requires even more structure
Trending Topics
#14
Banned
iTrader: (18)
Join Date: Aug 2003
Location: Wayne, NJ
Posts: 2,984
Likes: 0
Received 0 Likes
on
0 Posts
That is beautiful. George over here just got his z06 certified 25.5. I am going for the 25.2 cert over the winter time.
Good luck Fireball, which inspector are you dealing with? Bob Nixon is a great guy he's from PA too.
Good luck Fireball, which inspector are you dealing with? Bob Nixon is a great guy he's from PA too.