Which Cam & Heads for blower
12-22-2008, 02:03 PM
#1
Teching In
Thread Starter
iTrader: (3)
Join Date: Mar 2007
Location: indianapolis
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Which Cam & Heads for blower Trailblazer ss with a new forged bottomend ..lowered compression to 9.8:1
I have a small Gen.V MP112 magnuson supercharger , it is only good for about 8-9lbs max. This will have to do for now .
I plan on using this cam ( will this cam have any lope )
226 234 .598 .599 117
And these heads
GM 243 casting
5 axis CNC machined
Fully assembled
220cc Intake Runner
Intake Flow Rate 310 CFM
Exhaust Flow Rate 245 CFM
Stainless 2.020 Intake Valves
Stainless 1.575 Exhaust Valves
Anybody care to comment ? I am hoping that I did my homework .
I have a small Gen.V MP112 magnuson supercharger , it is only good for about 8-9lbs max. This will have to do for now .
I plan on using this cam ( will this cam have any lope )
226 234 .598 .599 117
And these heads
GM 243 casting
5 axis CNC machined
Fully assembled
220cc Intake Runner
Intake Flow Rate 310 CFM
Exhaust Flow Rate 245 CFM
Stainless 2.020 Intake Valves
Stainless 1.575 Exhaust Valves
Anybody care to comment ? I am hoping that I did my homework .
12-22-2008, 03:01 PM
#2
Seems like a good budget build. The cam listed will have a little bit of lope but nothing too radical. Only thing I would make sure is that you have enough fuel/octane running 8-9 psi and a real good tune. Good luck and post up numbers once you have them!
12-22-2008, 07:49 PM
#3
Trailblazer ss with a new forged bottomend ..lowered compression to 9.8:1
I have a small Gen.V MP112 magnuson supercharger , it is only good for about 8-9lbs max. This will have to do for now .
I plan on using this cam ( will this cam have any lope )
226 234 .598 .599 117
And these heads
GM 243 casting
5 axis CNC machined
Fully assembled
220cc Intake Runner
Intake Flow Rate 310 CFM
Exhaust Flow Rate 245 CFM
Stainless 2.020 Intake Valves
Stainless 1.575 Exhaust Valves
Anybody care to comment ? I am hoping that I did my homework .
I have a small Gen.V MP112 magnuson supercharger , it is only good for about 8-9lbs max. This will have to do for now .
I plan on using this cam ( will this cam have any lope )
226 234 .598 .599 117
And these heads
GM 243 casting
5 axis CNC machined
Fully assembled
220cc Intake Runner
Intake Flow Rate 310 CFM
Exhaust Flow Rate 245 CFM
Stainless 2.020 Intake Valves
Stainless 1.575 Exhaust Valves
Anybody care to comment ? I am hoping that I did my homework .