cals400ex

iTrader: (27)

i was curious if anyone knew what size the vacuum nipple is on the red procharger surge valve?

Blown06

iTrader: (32)

If your talking about the threaded part it is 1/8 NPT

02LS1ram

iTrader: (17)

^^ +2 on that

cals400ex

iTrader: (27)

i was trying to figure out what size hose goes over that nipple. i do not have the hose yet and i will need to purchase one.

Blown06

iTrader: (32)

Doesn't sound like you have the fitting that they usually come with from procharger. The one from procharger is normally a push in style, not a nipple that the hose goes over. Thats just from what I've seen on the new ones that I've purchased.

cals400ex

iTrader: (27)

well i am not sure what you call a "push in" style? i honestly do not know where the hose connects to. i was assuming at the threaded looking screw at the top. i must be wrong...

Bob@BruteSpeed

iTrader: (16)

Here is where the hose connect to the nipple. Bob

ChevyChad

iTrader: (50)

Yea, I'm not sure what you're asking either.. The hose that goes over the fitting that screws into the valve (as pictured by Bob above) is just normal 1/8" vacuum hose.

Monte4ever

iTrader: (2)

I recently purchased one and it came with a 1/8" NPT push/pull connector.

cals400ex

iTrader: (27)

well my red procharger valve does not have that connector that you have pictured. i guess i need to get one of those. thanks.