projectcam

iTrader: (12)

has anyone on here used this stuff to make there hot side? It is a hell of alot thicker and holds heat in better than mild steel. I am having my turbo kit redone and using this stuff, not sure why more people don't use it more?

HydroStream6

iTrader: (16)

It's more pricey. Good stuff though.

projectcam

iTrader: (12)

Its not that much more than mild steel really, a ubend cost 20 bucks and a mild steel bend is 14. Can't compare the two in quality.

pwrtrip75

iTrader: (8)

I use the stuff, and also see it used everywhere. Ive made a couple sets of headers and hot sides. Its the cheapest stuff I could find also...stainless that is. Its not going to stress crack like thin wall tubing either. Quality wise it is just as good as anything else...its not all shiny and polished... but who really cares.

LS1NOVA

iTrader: (12)

Where are you buying it from?

pwrtrip75

iTrader: (8)

mcmaster car webpage 16
http://www.mcmaster.com/#butt-weld-p...ttings/=aqckm7

The Beast

iTrader: (16)

No one beats the prices at acestainless.com

cracker

iTrader: (1)

alltexsupply

ModularTurbo

iTrader: (14)

Cracker has the hook up, we buy all that stuff from him. Thanks again for hooking us up today with those fitting for our TT kit.

TT350

Rob your a post *****.

Reject

iTrader: (24)

wtf they are in my backyard! how am i just hearing about them. how do you order up do you just call them telling them you need X amount of Y?

ModularTurbo

iTrader: (14)

Mr TT350:

Its you're aka you are a post *****.....


LOL

ModularTurbo

iTrader: (14)

pm cracker

PPI Typhoon

iTrader: (1)

I built my hot side out of SCH 10 stainless from Ace Stainless. No url allowed, but you can figure it out.

He has super fast shipping, and much better prices than McMaster.

I had some special bends, needing tight radius and whatnot. Everything was done schedule 10 on mine except for the downpipe, which I went to 4" 14g stainless.