Z28harcor

So I'm building my 8.8 rear and I'm slidding my 10 bolt tubes into the 8.8 tubes.. Problem is I cut the tubes off before I got the angle.. I kinda forgot.. So can some one give me the angles and where you took them from when the pinion is set to 0 with an angle finder please!!


I know this is the wrong spot to ask but noone ever goes in the gears and axles

yenkomike

iTrader: (2)

you will most likely have to mock it up and set the pinion angle to your car. that is the only way to get it right without guessing. tack it then pull it and weld.

Old Geezer

iTrader: (3)

^^^^^^^^ What Mike said.

MUSTANGBRKR02

iTrader: (91)

Post up in the gears and axles section. Someone there has the answers.

Blackpanther99

iTrader: (8)

Problem is that he already did but no one answered his questions. Lol

MUSTANGBRKR02

iTrader: (91)

Then look through build threads and pm some people. Go buy another rear from a scrap yard for 50 bucks and have a reference.

Blackpanther99

iTrader: (8)

OP... Just call Bob at brutespeed. Im sure he will get you setup.

MUSTANGBRKR02

iTrader: (91)

That is a good idea too or Eric @ MWC