Phil99vette

iTrader: (11)

First attempt at making headers, not really in love with the bend on the #2 runner, almost need to get a tighter bend.








Phil

StingrayCrazy

iTrader: (5)

Damn good

Post some more pics when your finished!

Frank

HUNTER02SS

iTrader: (24)

Looks good from my house.Great start you got there.

Phil99vette

iTrader: (11)

Thanks guys! I'm going to order some tighter radius bends for the shortest runner to clean it up. There is probably nothing wrong with it but stuff like that kills me until its fixed.
Phil

qqwqeqwrqwqtq

Or you could bring #2 to the outside as 4,6 and 8 have more room to make the turn to the inside.

frcefed98

iTrader: (16)

Looks great, big props to you for tackling a set of headers I always wanted to try it myself but i'll wait till I get a tig first. Keep postin pics of your progress!

J

Boo"SS"t

iTrader: (2)

Do you think you're somekind of an expert on these stuff or something??!!....... JK!!!

Phill99vette, I think you just got yourself a freebee advise from....only the baddest, sickest turbo kit builder on this planet!!!....nevertheless, it seems like you got yourself an awesome start. Looks great so far!
I only wish I have the ability to do something like that... .
BTW, is this for single or twin? ....again, great job!

Josh@KY-Turbo

iTrader: (120)

Very nice indeed. I would lave it like it is personally.

99Z28LS1

iTrader: (4)

that looks really nice, i wish i could do that

Phil99vette

iTrader: (11)

Here's the other side, I like this side much better.

Phil99vette

iTrader: (11)

Here is some pics of my welding, I'm getting better...

Josh@KY-Turbo

iTrader: (120)

Your welding doesnt look to bad at all. Headers look promising also.

blacktransam

iTrader: (13)

like a roll of nickels.. i love it

Tiago

iTrader: (27)

very nice

Moparnos (The SLP Guy)

iTrader: (55)

great job

Mr Powell

iTrader: (1)

Phil you never cease to amaze me. Looks bad ***!

Bird-Of-Prey

iTrader: (23)

Doesn't get much better than that. Nice job.

Speed

iTrader: (33)

Looks very good!

DMH Fabrication

iTrader: (126)

Looks good. 304 or 321 stainless? Are you just using the alum plate bolted to the engine for a reference for the amount of room between the frame rails?

Phil99vette

iTrader: (11)

I'm making a set out of Mild Steel and a set out of 304 SS. The ALuminum plate is a reference for the bottom tubes. Thanks for all the positive comments!