Hey Guys!!!
#1
10 Second Club
Thread Starter
iTrader: (38)
Join Date: Jan 2005
Location: Fresno, CA
Posts: 1,411
Likes: 0
Received 0 Likes
on
0 Posts
Hey Guys!!!
Well its been way to long!!! WEll me and ninetres went and picked me up a completly clean body v6 01 camaro! This time im building the motor. last time it was 10.2 on the stock bottom end on 9 psi this time im hoping for 18-20 psi!
keep in touch! ill post some pics of the shell
the grey car is the beater i drove to get me around for a few months haha
keep in touch! ill post some pics of the shell
the grey car is the beater i drove to get me around for a few months haha
Last edited by Mr_president; 09-04-2007 at 04:29 PM.
#7
10 Second Club
Thread Starter
iTrader: (38)
Join Date: Jan 2005
Location: Fresno, CA
Posts: 1,411
Likes: 0
Received 0 Likes
on
0 Posts
all the suspention, rear end only thing that took a **** was the pan hard bar . however the motor is cool trans is cool everything the gas tank is smashed but im sure my walbros a re cool...
Im going to make a for sell thread soon of a bunch of stock parts like brakes t-tops 3.8 motor , 4l60e, 10 bolt, Whole front end and so on.Ill make a little dough back I will take pictures of the build up,
QUESTION!!
What does the OBD2 read from when it comes to VIN and engine size, I know people swap there computers out all the time so im hoping its not from that and the module under the dash
Im going to make a for sell thread soon of a bunch of stock parts like brakes t-tops 3.8 motor , 4l60e, 10 bolt, Whole front end and so on.Ill make a little dough back I will take pictures of the build up,
QUESTION!!
What does the OBD2 read from when it comes to VIN and engine size, I know people swap there computers out all the time so im hoping its not from that and the module under the dash