STS questions
01-18-2008, 04:24 PM
#1
Teching In
Thread Starter
Join Date: Jul 2007
Location: Florida
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
STS questions just some questions about the STS kits for a TB SS...
what are some mods to go along with the kit? not looking to kill the block or anything but what kind of exhaust mods can go with the kit on the TB SS due to clearance and turbo placement, etc?
what are some mods to go along with the kit? not looking to kill the block or anything but what kind of exhaust mods can go with the kit on the TB SS due to clearance and turbo placement, etc?
01-18-2008, 05:15 PM
#2
TECH Resident
iTrader: (17)
Join Date: Sep 2004
Location: NC - Charlotte area
Posts: 3,747
Likes: 0
Received 0 Likes
on
0 Posts
i don't understand what a TB SS is ? i've been away from the forums for a little while... so excuse my ignorance. but in my signature is a link to my sts install
01-18-2008, 10:34 PM
#5
TECH Regular
iTrader: (11)
Join Date: Sep 2006
Location: P'cola, FL / Okc, OK
Posts: 405
Likes: 0
Received 0 Likes
on
0 Posts
I've actually seen a TB STS in a resteraunt parking lot and of course I had to take a look and far as I could tell it had the OE exhaust up to the turbo and had plenty of clearance from any dangerous body components and of course the road.
I would figure you could go a step larger with the exhaust piping to the turbo and maybe gut the cat. Of course a good tune, proper fuel delivery, and a wrapped hot side will do a lot of good!
I would figure you could go a step larger with the exhaust piping to the turbo and maybe gut the cat. Of course a good tune, proper fuel delivery, and a wrapped hot side will do a lot of good!
Trending Topics
01-20-2008, 12:00 PM
#9
TECH Resident
iTrader: (17)
Join Date: Sep 2004
Location: NC - Charlotte area
Posts: 3,747
Likes: 0
Received 0 Likes
on
0 Posts
wait, so what are you asking? you just want more/less exhaust to look neat? or what?
go to an exhaust shop or someone that welds/cuts stainless steel or some metal that can be used as exhaust and talk to them , they can do stuff
if you were here in charlotte i would tell you to go to Eric, Nick Williams friend, but id think you are around here
go to an exhaust shop or someone that welds/cuts stainless steel or some metal that can be used as exhaust and talk to them , they can do stuff
if you were here in charlotte i would tell you to go to Eric, Nick Williams friend, but id think you are around here
01-20-2008, 04:55 PM
#10
Teching In
Thread Starter
Join Date: Jul 2007
Location: Florida
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
wait, so what are you asking? you just want more/less exhaust to look neat? or what?
go to an exhaust shop or someone that welds/cuts stainless steel or some metal that can be used as exhaust and talk to them , they can do stuff
if you were here in charlotte i would tell you to go to Eric, Nick Williams friend, but id think you are around here
go to an exhaust shop or someone that welds/cuts stainless steel or some metal that can be used as exhaust and talk to them , they can do stuff
if you were here in charlotte i would tell you to go to Eric, Nick Williams friend, but id think you are around here
