anyone have any idea how to make a dual intank fuel pump harness
10-21-2011, 10:58 AM
#1
Launching!
Thread Starter
iTrader: (18)
Join Date: May 2008
Location: Macomb, Michigan
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
anyone have any idea how to make a dual intank fuel pump harness anyone have any idea how to make a dual intank fuel pump harness without A Hobbs switch. I have a big enough return line to run both all the time.
10-25-2011, 02:13 PM
#2
Sure, just tap into the pump relay's PCM trigger wire for the new relay and run fresh power wires to the battery and new pump
On the other hand, the purpose of the hobbs isnt to keep from overpowering the return (upgrade in that instance), its to minimize the stresses on the system when it doesnt need the extra fuel to extend the life of the pumps
On the other hand, the purpose of the hobbs isnt to keep from overpowering the return (upgrade in that instance), its to minimize the stresses on the system when it doesnt need the extra fuel to extend the life of the pumps
