is my A1000 enough? 3 questions
#1
Launching!
Thread Starter
iTrader: (2)
Join Date: Feb 2005
Location: Chesapeake, Virginia
Posts: 248
Likes: 0
Received 0 Likes
on
0 Posts
is my A1000 enough? 3 questions
quick questions. I already have a Aeromotive A1000 pump with all the lines, rails, regulator ect from my 347/d1sc build.
New build is a 402 twin turbo motor, looking to make 8-900 rwhp with a 90-120 lb injector on 93 pump gas. Will this pump be sufficient or do I need to step up to the Eliminator pump? Would like to do this without meth if possible for simplicity sake but am not opposed to going back to meth.
Question 2. I think this is enough injector to get the job done (if my math is right) but confirmation or constructive criticism is always welcome.
Question 3. at this level is it better/easier/more tune-able to go high impedance or low impedance with a driver box?
Thanks in advance
New build is a 402 twin turbo motor, looking to make 8-900 rwhp with a 90-120 lb injector on 93 pump gas. Will this pump be sufficient or do I need to step up to the Eliminator pump? Would like to do this without meth if possible for simplicity sake but am not opposed to going back to meth.
Question 2. I think this is enough injector to get the job done (if my math is right) but confirmation or constructive criticism is always welcome.
Question 3. at this level is it better/easier/more tune-able to go high impedance or low impedance with a driver box?
Thanks in advance