7.5 10 bolt repeating problem
09-27-2009, 03:30 PM
#1
Teching In
Thread Starter
Join Date: Apr 2008
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
7.5 10 bolt repeating problem I have a 2002 z28 A4 with exhaust, egr delete, 150 shot,ls6 intake and k&n air filter....
I have put 2 different sets of gears in my car (3.73-3.42) and both times after installation car ran drove fine with no noise or vibration....then after about 3 weeks of driving (sometimes hard) it starts shakeing from the driveshaft or rear end, and the gears start whining and one time went out completely, broke 4 teeth off the ring gear ( with 3.42) .....i put a complete new rear end in it out of a 95 trans am already factory built and it did the same thing........Im getting tired of wasting my time and money...what can i do to my rear end to make it hold the power , or do i need to get a better rear end???
I have put 2 different sets of gears in my car (3.73-3.42) and both times after installation car ran drove fine with no noise or vibration....then after about 3 weeks of driving (sometimes hard) it starts shakeing from the driveshaft or rear end, and the gears start whining and one time went out completely, broke 4 teeth off the ring gear ( with 3.42) .....i put a complete new rear end in it out of a 95 trans am already factory built and it did the same thing........Im getting tired of wasting my time and money...what can i do to my rear end to make it hold the power , or do i need to get a better rear end???
