tnmotown

iTrader: (107)

Just like title says. I got a Moser 9" and will be using my stock driveshaft. Now I understand I need the 1350 u-joint from NAPA for the driveshaft, but then what pinion yoke will I need on my 3rd member? I'm just kinda confused here, and did a lot of researching. Thanks everyone for any input.

P.S. any good sites for pic-by-pic installation process?

thechef

iTrader: (13)

what ever yolk is on your 9 inch is the yolk you need on your drive shaft
so if you ordered your 9 in with a 1350 yolk go to NAPA and get the 1350 yolk for the drive shaft

tnmotown

iTrader: (107)

Oh ok, makes sense. I just heard that there are like 3 or so different pinion yokes. Some are shorter/longer then others....?

welman transam

iTrader: (2)

the u joint you need is a precision #447 that is a conversion u joint because the stock driveshaft is not a 1350 just the yoke is i just did this 2 days ago.

tnmotown

iTrader: (107)

Yeah but I heard that the pinion yokes could be 1310/1330/1350 yokes? So I just assumed if those were different then the u-joint to the d/s will be different.