ASR, BRAKE, and ABS lights came on after rear end swap?!?
04-30-2010, 09:00 PM
#1
TECH Enthusiast
Thread Starter
iTrader: (6)
Join Date: Sep 2007
Location: Tucson, AZ
Posts: 585
Likes: 0
Received 0 Likes
on
0 Posts
ASR, BRAKE, and ABS lights came on after rear end swap?!? I recently installed a new MWC Fab9 rear end and drove it fine with no problems for a couple days. Well when I took the car out for a little drive today the ASR, BRAKE, and ABS lights all came on. So I pulled over to the nearest gas station and looked under the car and the harness is plugged into each abs sensor and into the plug on the car. I have no clue as to what it could be...
Has anybody else had this problem or know what it could be?
Has anybody else had this problem or know what it could be? 
05-01-2010, 11:41 AM
#3
The first thing I would do is to check all the connections, sensors, etc that were involved in the installation of the new rear. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
05-02-2010, 09:04 AM
#4
TECH Enthusiast
Thread Starter
iTrader: (6)
Join Date: Sep 2007
Location: Tucson, AZ
Posts: 585
Likes: 0
Received 0 Likes
on
0 Posts
Yeah I checked everything and all the connections are good. I did however find the problem. I threw on some 28" tires on the back and so the difference between the front tires and back tires are whats throwing the lights. Thanks for your input though!
