FasTimeSS

iTrader: (47)

I am switching to strange rear brakes on my brand new mwc 9". I cant for the life of me get the axles out am I doing something wrong. I removed 4 bolts hold the stock caliper bracket on. I cant get the axles to slide in they are like stuck on??? Can someone give me some advice as I am stuck here and need to get them off to put new brakes on.

weeble1

iTrader: (6)

Sometimes the axle bering is pretty tight to the housing. Have you tried tapping with a rubber mallet? Shouldn't be a c clip axle...

ss performance

iTrader: (17)

I have had to use a slide hammer to remove 9-inch axels.

Blowerman

They are tight sometimes. But when the axle tubes are bent their even tougher to get out. I broke a slide hammer getting mine out.
Short story. Eyeball your axle tubes when you get them out.

Bob@BruteSpeed

iTrader: (16)

Even though you have a brand new rear, you may need to use a slide hammer. Bob

KENS96M6

You can use a peice of 3/8" allthread and nut between the housing end and the axle flange to drive it out or like others have said, use a slide hammer. Good luck!

need4fun2469

I just removed mine. I used a rubber mallet on the back of the backing plate. They came out.