RamonGTX

So a while back I bought a drive shaft for my moser 9inch to a t56. I didnt think anything of it at first because I trusted Speed Inc. I ran into some personal problems and my car sat for a while. Well now I go to finish my build and they sent me something that is way off. Its 6 inches shorter than the stock one. I understand I cant return it because of how long it has taken for me to notice the problem but I trusted them and they wont at least say hey im sorry we sent you blah blah blah so I can figure out what it is.

Here are some pictures of how short it is....that way I can at least try and resell it and get some money back.

RamonGTX

Dont mind my 1 post count. I have been around a while I just lurk in the darkness and take it all in. Thank you

01ssreda4

iTrader: (96)

It looks like about 3 inches shorter and that's probably correct.

RamonGTX

it has to be an inch longer than stock for a t56 to a moser 9inch though and this is shorter

01ssreda4

iTrader: (96)

Well then somebody screwed up.

Jtm2085

iTrader: (1)

Yea that's most definitely to short. I was sent one by another vendor that was a hair to short and it caused terrible vibrations. Speed inc screwed the pooch on that one. You said you have contacted them about it? I don't see why they wouldn't replace it. It hasn't gotten shorter over time lol

RamonGTX

They are being incredibly difficult...first he assumed I didnt have a receipt to show what i was supposed to get. Then I sent him a picture of my receipt on my email. Every step of the way they have tried to push a new drive shaft down my throat and will not I mean will not even admit they sent me the wrong one. He basically told me I should have checked it the moment I got it...well my car wasnt done and I ran into problems...I trusted them to get me the right one the first time and now they wont stand behind their stuff.

MidwestChassis

iTrader: (5)

What is it the center to center?

RamonGTX

It is 39.75 from the rear ujoint to the ujoint on the slip yoke.

RamonGTX

39.75 from the center of the rear u joint to the front ujoint.

MidwestChassis

iTrader: (5)

You are about 2 1/8 shorter than what we would use but the slip yoke might also be longer than what we use but not by that much.

RamonGTX

Are those dimensions within any of the dimensions for other driveshafts? Basically now I'm trying to figure out what it fits so I can sell it.

MidwestChassis

iTrader: (5)

It would probably work with an S60 with a t56/4l60E but still be about .125 short by our measurements.

dailydriver

Is that an expensive carbon fiber shaft on top of being the wrong length
or is it just chromoly, or alloy powder coated black??

RamonGTX

It's just an HD driveshaft from speed Inc....$417 uneeded dollars.....ugh. Hopefully someone can get a good use out of it.