Gears & Axles Driveshafts | Rearends | Differentials | Gears | 12 Bolt | 9 Inch | Dana

Stock Gear Ratio

Thread Tools
 
Search this Thread
 
Old 02-21-2006, 01:02 PM
  #1  
Launching!
Thread Starter
iTrader: (6)
 
crewchef's Avatar
 
Join Date: Jul 2005
Location: Ringgold, GA
Posts: 278
Likes: 0
Received 0 Likes on 0 Posts
Default Stock Gear Ratio

Can anyone tell me what stock gear ratios were available for a 98 Camaro A4? I'm finishing up a conversion car, 88 T/A GTA w/ 98 LS1 and 2000 4L60E. Driving it to exhaust shop today was first time on the road. Speed looked to be showing about 10mph slower than actual (based on following friend). My tach is off too until I get the PCM programmed so it's tough to figure out what gear ratio the PCM is using right now. I'm guessing it's 2.73 but thought I would ask the question.
Old 02-21-2006, 01:33 PM
  #2  
TECH Senior Member
 
2001NBMZ28's Avatar
 
Join Date: Dec 2001
Location: Jacksonville, FL
Posts: 5,399
Likes: 0
Received 3 Likes on 3 Posts

Default

2.73 or 3.23
Old 02-21-2006, 02:29 PM
  #3  
Launching!
Thread Starter
iTrader: (6)
 
crewchef's Avatar
 
Join Date: Jul 2005
Location: Ringgold, GA
Posts: 278
Likes: 0
Received 0 Likes on 0 Posts
Default

Thanks, 2.73 was my best guess. It's not set for a 3.23 or it would be much closer the current rear end is a 3.27.
Old 02-21-2006, 03:57 PM
  #4  
Teching In
 
RedSlpZ's Avatar
 
Join Date: Mar 2005
Location: Merrillville, Indiana
Posts: 31
Likes: 0
Received 0 Likes on 0 Posts

Default

[B]Sticky ANybody??




All times are GMT -5. The time now is 03:22 PM.