SS1875

iTrader: (34)

Anybody know whether or not the Moser 8000 (1/2-20x3) Screw in Wheel Studs will work on a stock 10 bolt?? I know you have to run open ended lugs because of the length.

EPP

iTrader: (22)

Darren, the 10 bolt probably has press in wheel studs instead of screw in, plus they are going to be 12mm on the 10 bolt. Bob

chicane

Sure they will work... but you'll have to drill and tap the flange for the 1/2x20 pitch.

Jake@EPP

The stockers are press fit and ARP and moser make a 1/2 press fit as well. The key thing about the screw in wheel studs is the clearance behind the axle flange to make sure you have room for it.

The biggest issue i see is the time you have in converting a stock rear to run a stud that is stronger then it.

SS1875

iTrader: (34)

Thanks, I was trying too sell mine from the old 12 bolt and someone with a 10 bolt was asking me about them.