Superjoe

iTrader: (2)

I need to convert a 3-channel 10-bolt to a 4-channel 10-bolt to put in another car. What all do I need to do that? Just want to order whatever I need to minimize down time.


Thanks!

keliente

iTrader: (22)

A 3 channel rear into a 4 channel car is pretty simple. You will need the backing plates off a 4 channel car, the rear speed sensors that go into each backing plate, and the reluctor rings pressed on to each axle.

Superjoe

iTrader: (2)

Thank you. So would you say that it would be easier to get reluctor rings pressed onto the axles that I have or just get some 4-channel ready axles?

keliente

iTrader: (22)

Either way - just depends on what's available to you. When most people part out their 4 chans, they have already taken the reluctor rings for their next rear. Just a thought. So it might be easier to just buy reluctor rings from the dealer/vendor.

FirstYrLS1Z

iTrader: (4)

3 channel axles and 4 channel axles are different.The 3 channel axle does not have a machined boss to accept the reluctor ring.

wht01ws6ta

iTrader: (45)

So I just bought a used fab 9 inch with 3 channel and have a 4 channel 10 bolt on my car right now, do I have everything I need to convert the new 9 in to a 4 channel?