ls3 block bore.. how far can I bore it?
#1
Teching In
Thread Starter
iTrader: (2)
Join Date: May 2010
Location: Pennsylvania
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
ls3 block bore.. how far can I bore it?
I bought a block with a score in the cylinder due to swallowing a valve. I think .040 should clean it up. So, can I safely bore the block that far?
thanks.
thanks.
#3
LS1Tech Premium Sponsor
iTrader: (5)
We go .015" all the time without issues, but haven't tried .040". My gut says that won't be a good situation!
__________________
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
#4
Teching In
Thread Starter
iTrader: (2)
Join Date: May 2010
Location: Pennsylvania
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
ok, I just wanted to make sure. I did a little research from previous posts but wanted to see if anyone went over that limit.
It was really cheap anyway and I could maybe make a coffee table out of it. hehe
Thanks!!
It was really cheap anyway and I could maybe make a coffee table out of it. hehe
Thanks!!