Need help with 383 set up
10-12-2008, 11:40 PM
#1
Teching In
Thread Starter
iTrader: (5)
Join Date: Mar 2005
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Need help with 383 set up ok I have a 383 with callie rods crank and JE pistons livernoise stage 2heads that flow like 305 a 244 248 612 615 112 cam and a fast 90 stock fuel pump and maf and mac midlength headers..........car made 470hp and 426 torque
I have an ls6 maf and I just ordered a fuel pump
I want to break 500 maybe 510.......
should I do Kooks 1 7/8's or 1 3/4?
Trickflow heads, 215cc, 225cc, or 235cc?
and i'm goin to get a 92mm no matter whats.......please throw in some suggestions!
I have an ls6 maf and I just ordered a fuel pump
I want to break 500 maybe 510.......
should I do Kooks 1 7/8's or 1 3/4?
Trickflow heads, 215cc, 225cc, or 235cc?
and i'm goin to get a 92mm no matter whats.......please throw in some suggestions!
10-13-2008, 07:47 AM
#2
TECH Junkie
iTrader: (5)
Join Date: Feb 2007
Location: Key West, Florida
Posts: 3,183
Likes: 0
Received 0 Likes
on
0 Posts
better heads should do it. the TF 215s should make great power across the board, not sure how the 225s would work, but i doubt they would be BAD for the engine.
and why waste money on upgrading the FAST? spend the money on having it ported. you'll see more with that than the 2mm increase in mouth diameter.
and why waste money on upgrading the FAST? spend the money on having it ported. you'll see more with that than the 2mm increase in mouth diameter.
10-16-2008, 08:21 PM
#5
TECH Enthusiast
iTrader: (28)
Join Date: Apr 2008
Location: Grayson, KY 41143
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
what are the specs on the heads you have now? Couldn't you just have them taken a little further rather then have to purchase another set leaves more money in the pot for other parts. That you don't already have
10-16-2008, 08:44 PM
#6
TECH Addict
iTrader: (1)
Join Date: Nov 2007
Location: Narnia
Posts: 2,372
Likes: 0
Received 0 Likes
on
0 Posts
Just with long tubes dumped and a "good" tune, you should be very close to 500.
And like stated above, if you want just a tad bit more. Take the heads out a little bit more.
That should break 500 for sure.
And like stated above, if you want just a tad bit more. Take the heads out a little bit more.
That should break 500 for sure.
10-21-2008, 12:27 AM
#7
Teching In
Thread Starter
iTrader: (5)
Join Date: Mar 2005
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
well they flow 300 to 305 and have 64cc chambers they are livernoise heads I didn't knwo if trickflow had some special port design or something because everything i've seen with those head makes great numbers
