Switching from DBW to DBC, Cable Bracket Mount
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: Oct 2011
Location: Santa Clarita
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Switching from DBW to DBC, Cable Bracket Mount
I am switching my intake manifold capability from DBW to DBC in an early LS1 . The intake manifold has no provisions for the cable support bracket adjacent to the throttle body. The two points of contact (studs)where the bracket screws to the manifold are missing as compared to later intakes.
What is the recommended method to adapt the mount points to accept nuts for the two bracket screws now needed for the cable bracket? Thanks.
What is the recommended method to adapt the mount points to accept nuts for the two bracket screws now needed for the cable bracket? Thanks.