BigT2002

iTrader: (2)

I got the top part on no problem but the bottom part of the lid cannot or will not go completely over the bottom area of the MAF, but now I can't even get it back off because its tight on the top, can't even get a flathead in between the two to seperate them. The MAF fit perfectly with my whisper lid, but since it was cracked I had to switch it up with something different.

Any ideas on how to get it off and to get it to fit the way its supposed to?

neutron82

iTrader: (26)

mine was a total bitch to get on... i used a hair dryer and got the plastic warmed up and just kept working with it and it finally went on all the way... i hope i never have to take it off lol

BigT2002

iTrader: (2)

i figured that was going to end up being what I had to do

john shea

I heated my lid over the kitchen stove to get it on.

kinglt-1

iTrader: (26)

I used a dremel with a sanding disk. Ported out the lid opening to the maf. Slid right on with a little force.

fuseone

heat gun and alot of force lol

Starion

iTrader: (5)

I stuck my lid in the front window on a hot summer day for 30mins to soften it. Slid on much easier.