General Maintenance & Repairs Leaks | Squeaks | Clunks | Rattles | Grinds

01 WS6 very Rough idle, missfire on all cylinders.

Thread Tools
 
Search this Thread
 
Old 05-14-2012, 09:04 PM
  #1  
Staging Lane
Thread Starter
 
ccrook19's Avatar
 
Join Date: Mar 2011
Posts: 86
Likes: 0
Received 0 Likes on 0 Posts
Default 01 WS6 very Rough idle, missfire on all cylinders.

I have a 01 trans am ws6 with a T56.. car has about 53k miles on it bone stock i think.. it has no codes
no cracked vacuum hoses
New plugs and Wires
02 sensors are switching like they should and are not SLOW
it misfires at idle on "ALL CYLINDERS"..

any idea's??
Old 05-14-2012, 09:06 PM
  #2  
Staging Lane
Thread Starter
 
ccrook19's Avatar
 
Join Date: Mar 2011
Posts: 86
Likes: 0
Received 0 Likes on 0 Posts
Default

It has more then enough power and no misfires anywhere else but IDLE
Old 05-14-2012, 09:40 PM
  #3  
TECH Enthusiast
iTrader: (1)
 
DisasterFormula's Avatar
 
Join Date: Apr 2012
Location: West TN
Posts: 637
Likes: 0
Received 1 Like on 1 Post

Default

Try cleaning the maf, IAC, check voltage on the TPS.
Old 05-14-2012, 09:42 PM
  #4  
12 Second Club
iTrader: (8)
 
lynx853's Avatar
 
Join Date: Jun 2006
Location: NC
Posts: 191
Received 4 Likes on 2 Posts

Default

had the same problem after it sat for a month. Going to say the ethanol in the fuel absorbed water like mine did, drain the tank and put fresh gas in. I was chasing that gremlin for a few days.
Old 05-14-2012, 10:14 PM
  #5  
Launching!
iTrader: (21)
 
MurderedOut's Avatar
 
Join Date: Nov 2008
Location: Slidell, LA
Posts: 227
Likes: 0
Received 0 Likes on 0 Posts
Default

check for vacuum leaks and check the intake gasket. Ive had small leaks in intake gaskets cause small misfires on only one or two cylinders sometimes all, only at idle. the second you hit the throttle it goes away.
Old 05-15-2012, 11:42 AM
  #6  
Staging Lane
Thread Starter
 
ccrook19's Avatar
 
Join Date: Mar 2011
Posts: 86
Likes: 0
Received 0 Likes on 0 Posts
Default

Maf was cleaned multiple times, along with swapping with a known good one.. Iac on the scanner seams to act perfectly fine.. but haven't cleaned it at all.. and if there was low voltage to the TPS a code would be thrown right away...




All times are GMT -5. The time now is 06:16 AM.