Sweet71

iTrader: (10)

I have a vibration in my car, it gets real bad in third around 2000 Rpm Besides that it does it a little bit in fourth, any ideas what it could be?? Out of balance drive shaft, maybe wheels, or could i have a siezed u-joint, it also makes a bit of a clunk shifting into gear....So im thinkin it might be time for new u-joints...anyhelp is appreciated.

staringback05

iTrader: (8)

maybe a bad motor mount

BigDaddyBry

iTrader: (15)

Is it rhythmic or constant?

turners98ws6

i have almost the same problem ive changed almost everything.i had my a4 built,had fuddle 3600 changed it to a yank ss3600,changed drive shaft with new joints, built rearened,put zr1 17/11 on back had 17/9's,changed torque arm,put qa1 adj rear shocks,still vibs in third gear at about 3000. its worse when letting off the gas.i'm going to check axles and motor mounts.pm me if you find anything!

WAHUSKER

iTrader: (4)

Many of these trannies clunk when they shift. I've had vibes from over-tightened u joints, out of bal tire, bad drive shaft, and now with a solid trans mount I get it in 3rd gear....too many possibilites. Sorry.

Sweet71

iTrader: (10)

Its kinda constant to the rpm, and it does get worse when letting off the gas, dunno guess its time for the old trouble shoot one thing at a time till it stops, start with the cheapest and go from there, thaks for all the advice, when i figure it out i will post the problem

L67toLS1

iTrader: (4)

let me know, I'm having a similar problem, people have said everything from bottom end to spark plugs

TORK?

iTrader: (27)

Anyone check wheel bearings?

I had this problem on my full size truck. Sounded like a hum and slight vibration, ended up being front driver's side wheel bearing.

jond99

iTrader: (1)

I had a 94 camaro that did that, it was due to the driveshaft/u-joints.