No start problem?
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: May 2008
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
No start problem?
Hi guys need alittle help here. I just got done doing a heads and cam swap on my 02z. Heres my problem when I go to turn the motor over I lose all power. So far I have check the starter wiring also I have looked over my grounds and they all look to be in the right spot. One thing Ive noticed is all the gauges sweep to the left when I loose power but the oil pressure gauge. It goes right I dont what to do. Any suggestions?
Last edited by 02'z; 07-18-2008 at 12:17 PM.
#2
Staging Lane
Join Date: Nov 2007
Location: Hutchinson, KS
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Ensure the positive and negative terminals and all power/ground leads are corrosion free and tightened up. I had this same problem when I had to put a new motor in my 99 V6. The accessories and lights would come on but as soon as I tried to crank everything went dead, and the gauges shot all the way up and back. Good luck.