torque loss between 1 3/4 & 1 7/8
#1
Teching In
Thread Starter
Join Date: Apr 2007
Location: Mt. Vernon,WA
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
torque loss between 1 3/4 & 1 7/8
I know there is a dyno comparision on here somewhere but I am about to order American Racing headers tomorrow and am leaning towards 1 3/4 primaries cause I want to keep as much torque for pulling in the 2000-2500 range. 228 or 230 dur cam is next. Does anyone know where that thread was on the dyno graphs between 1 3/4 and 1 7/8 LTs was & did it record numbers that low. Or is there any other input about this? SBC experience would tell me to stick with the smaller but LS motors seem to like a little more. 2800lb car & 3.7 rear, stock 241's Opinions please, TS guys?
#4
Teching In
Thread Starter
Join Date: Apr 2007
Location: Mt. Vernon,WA
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
ok ARH 1 7/8 ordered!
OK, I placed my order for 1 7/8. All my 1st gen SBC experience tells me no but they don't breath like these. Now if I could only decide between the TSP228 and Torquer V2 cams. Leaning towards the T2.