Midnight00SS

Is it worth getting? I have full exhaust a tune, and a lid, and a ported and polished maf ends, wut do u guys think?

CamaroGuy83

I asked about one on here, and everybody told me its really just a looks mod. Doesn't give much performance if any. So for $60 or more, depending on where ya look, i decided against it, for now.

Midnight00SS

yea if its a look mod i dont wanna waste money lol

somws6bird

No you don't need it, spend the money on something else

BOBS99SS

iTrader: (2)

Not worth the money,there is a write up on making one for a couple bucks from homedepot,but even that's not even worth the time,money wasted

masterz28

iTrader: (8)

I say do get one, but not a SLP bellow cuz its just a mark up. The real hose only cost about 10-20 shipped. Check out this site.
http://intakehoses.com/Merchant2/mer...egory_Code=SC4

01ssreda4

iTrader: (96)

They have legit knockoffs on ebay. I bought one. It was around $30 IIRC. It is an appearance mod, but worth it to me

TheBlueKnight

iTrader: (4)

Bought the SLP bellow to replace that hideous accordian style. Wanted a nice pre formed style bellow, not some junky looking tube from Home Depot. And the 15rwhp gain is nice as well.

NBM99SS

iTrader: (33)

TheBlueKnight

iTrader: (4)

WS6 Rampage

iTrader: (3)

I agree with you.

I however bought the SLP Bellow but agree with searching for one on eBay if you desire it.

RyanJM

I got a slp to replace the ugly factory setup bit scores mine on eBay for $30 shipped. Watch for auctions sams bid in the last 30 seconds and sometimes you get lucky. Saved over $50 on my Volant intake like that as well.

senicalj4579

iTrader: (41)

My ss had one on the car when I bought it. Idk if it gains anything or not. I dont think its worth buying IMO. If you want something like that just make something like alot of people do out of material at home depot or something.

MikeWS6

save your money

DeLaRosa25

iTrader: (10)

I bought a Fernco from H.D. Was I think $6.XX

Never had a problem with it.

Midnight00SS

15rwhp? no way

King Nothing

iTrader: (9)

i bought a fernco and the piece of **** wouldn't stay on, the rubber is so hard and wont flex which causes it to come off when the engine flexs from revving up or just giving it throttle

Midnight00SS

ok forget it than lol

King Nothing

iTrader: (9)

yep lol might as well stick with the stock accordion style IMO

Mike454SS

iTrader: (4)

I have an SLP on mine, but I got it for almost nothing...it was too long, had to trim it as it was making the lid not seal properly in the back...it looks nice as long as you keep on top of cleaning the dust off of it...dust likes to stick to silicone couplers. I really don't think there was any power gain at all, but it certainly didn't hurt anything.