zaaronz

iTrader: (13)

I pulled my lid off today to take out the iat sensor and rubber ring, to put in my new slp lid. When it pulled out it somehow broke the little guard around the tip of the sensor. It looks ok still- just doesnt have that guard/shell. Should i put this back in- or just buy a new iat sensor??

RARON455

iTrader: (35)

Try and run it that way, If it doenst throw any codes itll prolly be fine, that gaurd is to protect the tip. I would consider replacing it though so you know its working correctly.

parks450

iTrader: (17)

ID buy a new one. That way its not always in the back of your mind that its gona fail. More of a piece of mind thing I guess.

patSS/00

iTrader: (6)

I'd use it. If it's broken you'll get a code, then easy enough to replace. But it's probably fine, those sensors are about as simple as you can get, the only thing that can go wrong is a broken connection.

zaaronz

iTrader: (13)

yea i put it back in - it was fine