Turn down pipe for Q-TEC electric cut-out!!
#1
Teching In
Thread Starter
Join Date: Feb 2004
Location: san jose CA
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Turn down pipe for Q-TEC electric cut-out!!
I am running the single cut-out on my car and would like to know where to get and what size to get of a little turn-down pipe or fitting so it aims the flow of my cutout down. my car is lowered so it would need to pointdown or over a few inches and down without going any closer to the ground. would love any help on this.
#4
Moderator
iTrader: (11)
Join Date: Mar 2002
Location: East Central Florida
Posts: 12,605
Likes: 0
Received 6 Likes
on
6 Posts
Mine, I flanged with a little 3" header stub with
the idea of putting a short turndown later. Has
to be real short, as I'm close to the axle. But I
have not found any short turndowns yet... the
AutoZone had a heavy exhaust pipe type that
turns down a whole 2" in a 6" distance... woo-hoo.
I reckon I may just have to get a piece of SS pipe
scrap from a tight-radius bend and cut it to fit.
Have not seen any High Performance Chrome Muffler
Tips at these places in 3", only 2"; I guess they're
more for the Old Skool Pea-shooter Duals crowd.
the idea of putting a short turndown later. Has
to be real short, as I'm close to the axle. But I
have not found any short turndowns yet... the
AutoZone had a heavy exhaust pipe type that
turns down a whole 2" in a 6" distance... woo-hoo.
I reckon I may just have to get a piece of SS pipe
scrap from a tight-radius bend and cut it to fit.
Have not seen any High Performance Chrome Muffler
Tips at these places in 3", only 2"; I guess they're
more for the Old Skool Pea-shooter Duals crowd.