WhAt bellow to use for 104 lid and 100mm maf
04-16-2014, 12:21 PM
#1
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jan 2006
Posts: 1,782
Likes: 0
Received 0 Likes
on
0 Posts
WhAt bellow to use for 104 lid and 100mm maf I have a 100mm maf and 104mm lid. The two holes do not line up at all and there is about an inch to inch and a half difference. I also don't have much room to play with as the gap is very short inbetween the two. Need help!!! Thanks
04-16-2014, 02:29 PM
#3
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jan 2006
Posts: 1,782
Likes: 0
Received 0 Likes
on
0 Posts
Really?! Mine is completely off. Idk if it's bc it's an iron block or what that's pulling it down. But it probably an inch away from eachother but the lid opening sits and inch higher than the maf opening
04-16-2014, 02:46 PM
#4
10 Second Club
Mine came from intake hoses.com. I think it was a 4" (22 or 30) degree bend. Just needed trimmed. If your maf is smaller than the lid use black tape to go around the maf until it fits snug.
04-16-2014, 05:47 PM
#6
Try cutting the ends at an angle. That should fix your problem. It tends to do that if you have a Ram Air lower airbox like the WS6 cars have.
Lonnie
Lonnie
__________________
NOW OFFERING TSP BY YANK CONVERTERS
COMP - FAST - PACESETTER - WISECO PISTONS - LUNATI - CALLIES - NEW TSP BRAND CRANK & RODS - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - ARH HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - PRECISION INDUSTRIES - YANK - CIRCLE D - AND MORE!
COMP - FAST - PACESETTER - WISECO PISTONS - LUNATI - CALLIES - NEW TSP BRAND CRANK & RODS - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - ARH HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - PRECISION INDUSTRIES - YANK - CIRCLE D - AND MORE!
NEW NUMBER (512)863-0900