exhaust prob
#1
Teching In
Thread Starter
Join Date: Nov 2002
Location: Spartanburg, South Carolina
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
exhaust prob
we determined yesterday that the header on the drivers side is rubbing what i think to be the k member. the headers came with that little dimple in them but its obviously not big enough... what do yall think i should do and will it hurt andything to grind down the k member a little to get it off the header a little bit?
#2
TECH Fanatic
iTrader: (41)
Join Date: Mar 2004
Location: mass
Posts: 1,514
Likes: 0
Received 0 Likes
on
0 Posts
yea, you will have to cut a little notch in the k member. it wont hurt anything, just use a dremel tool and cut a small notch in it. i had to do this a couple months back with my friend pacesetters. good luck