Upgrades to intake?
06-11-2014, 09:47 AM
#1
Staging Lane
Thread Starter
Join Date: Apr 2013
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Upgrades to intake? In my swap, I only have room to run shorties, although they are not as good as long tubes, they are still a tiny bit better than manifolds.
4.8/t56
Cammed
Spring'd
shorties.
One upgrade I wanna do is intake, but I don't wanna pay for an ls6 intake (too expensive) .
Is $225 dollars plus shipping a good deal for a TBSS/NNBS manifolds with rails and injectors?
And then $100 bucks for a 92mm TB?
And then exhaust, in NC you cannot run a cutout that bypass's any emission or muffler devices. So after my 'Converter', I was going to run a cutout pipe, and then cutout, then instead of just dumping it, having it run into like a straight through small glass pack. Its not bypassing a muffler because the exhaust is still going through one, and its already went through the converter.
Kinda like the corvette exhaust, but more red neck. Anyone done this before?
4.8/t56
Cammed
Spring'd
shorties.
One upgrade I wanna do is intake, but I don't wanna pay for an ls6 intake (too expensive) .
Is $225 dollars plus shipping a good deal for a TBSS/NNBS manifolds with rails and injectors?
And then $100 bucks for a 92mm TB?
And then exhaust, in NC you cannot run a cutout that bypass's any emission or muffler devices. So after my 'Converter', I was going to run a cutout pipe, and then cutout, then instead of just dumping it, having it run into like a straight through small glass pack. Its not bypassing a muffler because the exhaust is still going through one, and its already went through the converter.
Kinda like the corvette exhaust, but more red neck. Anyone done this before?
