krstull93

I can fit 2 11" fans on my Griffin Rad. What is a good fan to use in an 11? I have read that cfm isnt always the best, also have read that cfm and amps go hand in hand. I am mainly asking around for personal use.
Thanks in advance,
Kyle

conan

iTrader: (5)

What are the dimensions of your radiator core. Spal makes some nice high CFM fans. Stick with pullers too, they move more air VS pushers.

garys 68

iTrader: (1)

Your best bet is an OEM GM/Ford/Chrysler fan shroud combo that fits your radiator.
They move a lot of air, cost a lot less than good aftermarket fans, and will be available at any parts store if you need to replace.

krstull93

I have a griffin rad that is recessed into the core support of my f body, the core available is 22.5" w x 12" h roughly. I have an s475 infront of the motor but I just may have enough room to squeeze some thin pullers. If I can run pullers I will have more height to play with. I can measure this afternoon and see what I can run for pullers

conan

iTrader: (5)

See how much room you have for pullers. You could also do 1 pusher and 1 puller if you cant squeeze 2 pullers. Do you still have the air dam on the core support to force air up from the bottom ?

1970camaroRS

iTrader: (8)

If you can fit an OEM fan, do it.