moekluse

iTrader: (2)

Sorry if this is a dumb question but I just wanted to verify before I purchased.

I have a ported ls2 manifold going on bone stock motor, no boost or anything.

I see here that the map sensor is attached by what looks like a clip right behind throttle body. I thought ls1 map sensors were attached by a bolt in the back of the intake.

I just wanted clarification that this one below that it would fit my ls2 manifold

I appreciate any help, thanks

moekluse

iTrader: (2)

Anyone?

sjsingle1

iTrader: (1)

I dont know about the ls2 mani....but the ls1 and ls6 mani has a clip on top of the rear bung to hold the map down

sjsingle1

iTrader: (1)

https://ls1tech.com/forums/generatio...ap-sensor.html

pic in post 6

moekluse

iTrader: (2)

isn't that just the vaccume port for the brake booster? I swear I saw a diagram that also said ls2 map sensor was right behind TB

sjsingle1

iTrader: (1)

the large nipple on the bung is for the brake hose booster.....the hole is for the MAP... right below the MAP hole is the hook that holds the MAP in place......the smaller nipple is for HAVC

moekluse

iTrader: (2)

I'm only seeing 2 ports back here. No holes Ports in back
This is where i thought it goes

bbond105

06 GTO LS2 Map sensor. It is on the passenger side behind throttle body.

moekluse

iTrader: (2)

Yes that's it, is it possible to give me the part number if you can easily see it and a close up pic?

I would really appreciate it

bbond105

I will try to get a pic tomorrow. Its on my son car.

bbond105

16212460

moekluse

iTrader: (2)

thanks a TON, I really appreciate it

bbond105

You're welcome.