Need help with hanger locations
#1
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Dec 2001
Location: Upper Marlboro, MD
Posts: 1,297
Likes: 0
Received 0 Likes
on
0 Posts
Need help with hanger locations
I wanna have my buddy fab up a true dual system, but all the times he's been under my car he always says theres no place to weld the hangers. He rants on about how the floorboard is probably too thin to do any heavy welding on, and that the exhaust pipe next to the fuel lines on the drivers side is bad, blah blah blah I need good pictures of where your hangers are so I can show this fool where to weld them so he can stop complaining and do my exhaust. Thanks
#4
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Dec 2001
Location: Upper Marlboro, MD
Posts: 1,297
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by psykoTa
I have seen a lot of people use: the tunnel brace bolt holes, driveshaft loops. There are plenty of places, what type of duals are you doing? Over the axle, dumped, side exit?