00RedWs6

If so who did it and do you have any before and after #s

01 Red WS6

iTrader: (4)

I have one. I don't have any before numbers though sorry

00RedWs6

who did it? Did you have it on the car before and after to compare?

01 Red WS6

iTrader: (4)

The shop is gone but it was Arlington Motorsports

I had the car when it was bone stock and with the ported intake but I also got my asp pulley done at the same time so I cant really say what the intake did on its own but I doubt I would have noticed the 5-15 hp that I hear it gives.

M6HuggerSS

i belive the majoraty of the porting is to port match to the cylinder heads....

i heard its only about 2-4rwhp..... un-noticeable

SmaknaSS

iTrader: (1)

I port matched my LS6 intake to my 205's, I didnt notice any gain's, Ill have to dyno to tell. I'll post again when I dyno my car again.

00Z28 Camaro

, I know I wouldnt

lsx24

iTrader: (45)

I have one from Cartek, no before after numbers just after. The TB neck was enlarged also good for eight to ten wheel horses plus or minus depending on who did it. Check out my web page for pics.

ls1mojo

So, nobody can come up with any dyno graphs or real numbers??? That's unbelievable.

M6HuggerSS

to be honest, its really not worth the time or effort!
if your motor needs runners bigger than the LS6, you need the 90/90 FAST!

jmo.

Full-Force

iTrader: (11)

I think the best thing to di is get it extrude honed. That will open it up all the way through smooth. It doesnt do alot to open it up just at the exit of the intakes runner.

ls1mojo

Possibly, absolute speed used to have an affordable special for ls6 porting, unfortunately they are no longer in business. However, there may be some fbody enthusiasts that have one or tested one and just haven't gotten a chance to dyno or track.