V-10 Killer

iTrader: (22)

There's no place to ask this, and I can't find any good pics on sponsor sites, so I'll ask where many people are buying Kooks 1 7/8" headers. Does anyone have any pics of their Kooks headers and y-pipe installed on an F-body? Either with the ory, catted y, or x-pipe setup. I'd like to see how far they hang down compared to my subframe connectors.

Thanks

ls1-ss

iTrader: (1)

I dont have any pics of mine plus my pc is down right now so I couldn't post even if I did, but I can tell you that I don't have any clearance issues with mine and the roads around here leave a little to be desired. I don't think they sit much if any lower than my subframes. I'm also at factory ride height so that helps with the roads.

My pc should be up and running on Sunday if I can figure out how to post pics I will take some and post them for you

SDB

iTrader: (7)

I have the 1 7/8 to 2" stepped race headers, 3 1/2 collectors, 3" Kooks Y pipe with 3 1/2" inlet and outlet, stainless works 3 1/2" rear exhasut. It fits tight, but very nicely and doesn't hang down at all....My car is lowered 1.5" and have pleanty of exhaust clearance.

V-10 Killer

iTrader: (22)

Dang, that's pretty good! I know I didn't have any real contact issues with my Jet Hot setup, and my car is lowered ALL of 2". My spohn torque arm crossbrace, however, is another story...

Bombguy99z28

I have kooks 1 3/4, diamond subframes, and spohn torque arm running eibach prokit springs. I'll take some pictures this afternoon and post them.

JGA

Hi

I believe this is a view from the back of the Kooks Y pipe. It is not my car, I found this photo on the web.

JA