ashade98

iTrader: (16)

I'm installing my pacesetters, and on the drivers side I had to loosen up my POLY motor mount to slip that sucker in.

Do I need to re-install the heat shield that covers the motor mount? Wasn't going to bother unless it's critical.

Cstick

Pretty sure I left mine in my stock parts pile in the garage.

Keenov

iTrader: (5)

Yea, I tossed the heat sheild in both of my cars. No problems.

Redneck Z

iTrader: (3)

Doesn't the heat shield protect the alternator from the heat of the longtubes?

Full-Force

iTrader: (11)

Junk the heat shield. You probably just needed to swing the steering shaft out of the way instead of fooling with the motor mount. It takes a whole 2 minutes to do.

Tkami129

iTrader: (3)

i put the heat shield back on...its not that big of a job and it gives me a peace of mind knowing that it wont affect the alternator

schultzsj

iTrader: (1)

I just installed the driver's poly mount and I put the heat shield back in - I still have all the exhaust system shields in place. Since headers produce even more heat than the stock exhaust it makes sense to me to retain them.

Steve

you2slo

I took almost all mine off after the header install. I did leave the motor mount shield on. I don't want to replace it just because I wanted to save .5 ounces.